Tripp-Lite B162-001-POE Guia De Inicio Rapido página 9

Software Configuration
1. Assign an ID to all units.
A Use the Prev (+) / Next (-) Buttons to assign an ID to all
B Use the Prev (+) / Next (-) Buttons to assign an ID to all
Press the Tx / Rx Switch Button to switch the control to Rx.
The Rx LED will illuminate.
2. Assign a source to each of the transmitter units.
A Press the Tx / Rx Switch Button to switch the control to
B Use the Prev (+) / Next (-) Buttons to assign an input to
3. For remote management, the extender can be configured
and managed using the web GUI (DVOE Manager) or the CLI
Commands.
Web GUI (DVOE Manager) Login Procedure:
1. Download the IP Installer Utility from tripplite.com/support.
2. Use the utility to look up the IP address of your unit.
3. Open a web browser (such as Chrome) and enter one of the
IP addresses you obtained using the IP Installer Utility.
4. Select Administrator or User and type password in the
Password field.
-06-096-933E85-Book.indb 9 -06-096-933E85-Book.indb 9
transmitter units.
receiver units.
Tx. The Tx LED will illuminate.
the units.
9
10/18/2021 1:55:38 P 10/18/2021 1:55:38 P