Mopar RAM AIRFLOW Manual Del Usuario página 10

9
20. If necessa r y remove rear cover assembly by
lifting the rear two corners and pivoting forward and
separating it from the front inlet cover, save for
reinstallation.
NOTE: Ensure the tab on the IAT sensor faces down
or toward the throttle body clamp when installing.
21. Attach the air intake hose clamp to the air intake
hose. Then install the IAT sensor into the air
intake hose.
Push the IAT sensor until it snaps through and the
tab is flush in the groove on the boss surface.
July 19, 2019
www.mopar.com
K6864061AA