Mopar RAM AIRFLOW Manual Del Usuario página 5

4
5. Disconnect the wire harness connector from the inlet
air temperature (IAT} sensor.
Then disconnect the (MUA) make up air hose from
the clean air duct.
6. Loosen the clamp at the air cleaner and remove the
clean air duct assembly.
7. Lift tab slightly and twist counter-clockwise to remove
the IAT sensor from the air in take tube. And remove
the air intake hose clamp.
Save all for reinstallation.
July 19, 2019
www.mopar.com
K6864061AA