Work Area Safety; Electrical Safety - BGS technic 9294 Manual De Instrucciones

CONTENT
1 Foam cone
2 Foam disc
3 Foam disc (waveform)
4 Polishing disc (thick)
5 Polishing disc (thin)
6 Loop fastener disc
7 Grinding disc
8 Polisher
9 Handle
10 Charger
11 Bag
ACCESSORIES (optional)
9294-1 Replacement battery
9294-2 Quick charger
ATTENTION
Read and understand all instructions. Failure to follow all instructions listed below may result in
electric shock, fire, and/or serious personal injury.
SAFETY INFORMATIONS
DANGER!
People with electronic devices such as pacemakers should consult their physicians before using this
product. Operational or electrical equipment in close proximity to a pacemaker could cause interference
or failure of a pacemaker.

WORK AREA SAFETY

Keep your work area clean and well lit. Cluttered benches and dark areas invite accidents.
Do not operate power tools in explosive atmospheres, such as in the presence of flammable liquids,
gases, or dust. Power tools create sparks which may ignite the dust or fumes.
Keep bystanders, children, and visitors away while operating a power tool. Distractions can cause
you to lose control.
Dust created by power sanding, grinding, and other construction activities contains chemicals known
to cause cancer, birth defects or other reproductive harm. Same examples of these chemicals are
lead from lead-based paint, crystalline silica from bricks and cement, arsenic and chromium from
chemically-treated lumber and other masonry products. To reduce your exposure to these chemicals,
work in a well ventilated area and work with approved safety equipment, such as dust masks that are
specially designed to filter out microscopic particles.

ELECTRICAL SAFETY

Battery operated tools with integral batteries or a separate battery pack must be recharged only with
the specified charger for the battery.
Do not expose power tools to rain or wet conditions. Water entering a power tool will increase the
risk of electric shock.
Contact with a live wire will also make exposed metal parts of the tool live and shock the operator.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Cordless Polisher Set,
max. 2800 rpm, 10.8 V, 2.0 Ah,
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
1
6
4
5
2 3
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
BGS 9294
11
8
10
7
9