Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Air eccentric angle Sander / Burnisher
TECHNICAL DATA
Sanding pad: 50 mm (2")
Free speed: 10,000 RPM
Working pressure: 6.3 bar (90 PSI)
Avg. air consumption: 113 l/min (4 CFM)
Air inlet: 1/4"
Recommended air hose: 10 mm (3/8")
Noise level: LpA= 87 dB(A)
LwA= 98 dB(A)
Vibration: ahd= 8.5 m/s² / K= 1.5 m/s²
Length: 170 mm
Weight: 630 g
SAFETY ADVICE
Read and understand and follow all instructions and warnings before operating this tool.
Failure to do so may result in personal injury and/or property damage and will void warranty.
•
Be sure air is in OFF position when connecting tool to air supply.
•
Always wear approved eye protection when using tools.
•
Use only those accessories that are designed for use with tools. For example, with impact wrenches
do not use ordinary sockets. Use
•
Be sure to disconnect tool from air supply before changing accessories, performing service on tool,
and when not in use.
•
As with any tool, use common sense when operating. Do not wear loose clothing or
could become caught by moving parts, causing injury. Operate tool a safe distance from yourself
and others in the work area.
•
Follow air source manufacturer's directions for connection of regulators, filters, and other
accessories to air source. Do not install quick couplers directly on tool as they put unnecessary
strain on the air inlet threads possibly causing them to wear out prematurely. Instead, install them
on a short length of air hose attached to the tool.
AIR SOURCE
Clean air of correct air pressure is recommended for the power supply for this tool.
•
Make sure that the air compressor being used for the air tool operation supplies the correct output
(CFM).
•
Use normal 90 psi air pressure while running the tool. A maximum of 90 PSI at the tool is
recommended for most air tools of this class. The pressure must not be higher than 90 PSI on the
running tool. Use an in-line pressure regulator with gauge if air inlet pressure is critical.
•
Depending on length of air hose and other circumstances, air pressure at compressor may need to be
increased to 100 PSI to ensure 90 PSI at the running tool.
•
High pressure and unclean air will shorten the tool's life due to faster wear and also may create a
hazardous situation.
•
Drain water from air compressor tank daily, as well as any condensation in the air lines. Water in the
air hose and compressor tank contributes to reduced performance and damage of the air tool. Drain
the air tank and filters before each use and as necessary to keep the air supply dry.
SW-Stahl und Werkzeugvertriebs GmbH
5
d i e
impact
sockets for all air tools.
6
e
s
s
a r t S
h
c
s
m
e
R
If
raising dust, wear a suitable mask.
Tel. +49 (0) 2191 / 46438-0
r e
F
ax +49 (0) 2191 / 46438-40
s
u
k r e
v
e
7
9
8
2
4 -
D
e
9781
jewellery
L
d . l h
a t s
w
s
that
@
o f n i
: l i
Publicidad
Tabla de contenido
