Hansgrohe AXOR Stark 10100800 Instrucciones De Montaje página 6

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 9
Assembly (1)
Attention! The fitting must be installed, flushed
and tested after the valid norms!
Attention! The mixer must be connected to angled
or straight isolation valves with integrated filter. The
mixer can not used together with a continuous flow
water heater.
1. Flush through the supply pipes.
2. Place the mixer including the sealing washer in
position on the basin.
3. Slip the slide washer, washer and collar nut
over the threaded base and tighten the collar
nut by hand.
4. Tighten screws.
5. Connect the supply pipes to the isolation
valves;
cold right - hot left.
6. Install the battery (please see Exchange bat-
tery).
The hot and cold water supplys should be of equal
pressures.
Operation (10100800)
The water temperature is adjusted by the adjusting
lever.
move forward = cold water,
move backward = hot water.
6
English
cover
infrared sensor with
light emitting diode
(LED)
adjusting lever
(10100800)
Adjustment (2)
This mixer has the following feature:
background fade-out with integrated range
adjustment, that means the mixer is automatically
adjusted on to the local conditions (washbasin,
brightness, reflection) by the sensory mechanism.
Exchange battery (3)
The mixer operates with a 6 V Lithium-Battery (DL
223A). The working life of the battery is 2 years
by extremely operation. Over night the current
consumption is reduced by a economy mode.
Push a small allen key into the hole at the
backside of the mixer and pull the cover upwards.
Take care of the O-ring.
Attention: After installing the battery, the
mixer may not be activated for 1 min because of
adjusting itself.
LED-Display
LED off:
LED light:
Technical Data
Operating pressure:
Recommended operating pressure: 1 - 5 bar
Test pressure:
Hot water temperature:
Recommended hot water temp.:
Rate of flow:
Maximum flowing-out temperature
at 50 K temperature difference
and 3 bar flow pressure:
Follow-on time:
Rise-delay time:
Automatic switching-off:
Battery:
Spare parts (see page 3)
1
battery
2
connection hose
3
battery box with cover
4
aerator cpl.
5
fixing set
normal operation
replacing battery
max. 8 bar
16 bar
max. 80 °C
65 °C
6,5 l/min 3 bar
42 °C
1,5 s
300 ms
after 1 min
6V / 1300 mAh
Lithium
97399000
97456000
96317800
94005800
13961000

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Axor stark 10105800

Tabla de contenido