Danby DRC14A1BD Manual Del Propietário página 7

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

INSTALLATION INSTRUCTIONS
FIXING BRACKETS
1. Place the unit on a stable, smooth surface. Do not apply force onto any protruding controls.
2. Secure the cooktop to the work surface by screwing the four brackets on the bottom of the cooktop.
A. Screw
B. Retaining bracket
C. Screw hole
D. Bottom case
C
CAUTIONS
1. The cooktop must be installed by qualifi ed
personnel or technicians.
2. The cooktop must not be installed next to cooling
equipment, dishwashers or dryers.
3. The cooktop must be installed such that better
heat radiation can be ensured to enhance its
reliability.
4. The wall and induced heating zone above the
work surface shall withstand heat.
5. To avoid damage, the sandwich layer and the
adhesive must be resistant to heat.
6. A steam cleaner must not be used.
A
B
D
CONNECTING TO MAIN POWER SUPPLY
A 3 wire, single phase, 120 V, 60 Hz., AC only
electrical supply is required on a separate, 20 amp
circuit, fused on both sides of the line.
The cooktop should be connected directly to the
junction box through fl exible, armored or non-
metallic sheathed, copper cable. The fl exible,
armored cable extending from the fuse box or
circuit breaker box should be connected directly to
the junction box.
Locate the junction box to allow as much slack as
possible between the junction box and the cooktop
so that the cooktop can be moved if servicing
becomes necessary in the future.
Do not cut the circuit. The length of conduit provided
is for serviceability of the cooktop.
A UL listed or CSA approved conduit connector
must be provided at each end of the power supply
cable at the cooktop and at the junction box.
6

Publicidad

Tabla de contenido
loading

Tabla de contenido