Uline H-6859 Instrucciones De Montaje página 4

12. Once door panels are attached, each hinge may
need to be adjusted to align the doors. To adjust
the depth of the doors, tighten or loosen the rear
screw in the hinge. To adjust the angle of the doors,
tighten or loosen the center screw in the hinge.
(See Figure 10)
Figure 10
Door Depth
PAGE 4 OF 12
ASSEMBLY CONTINUED
Door Angle
1-800-295-5510
uline.com
13. Align handle (F) with holes in right door (9). Insert two
M4 x 22 mm screws and secure. Repeat for
remaining handle. (See Figure 11)
14. Align S-bracket from lock set (G) with holes in left
door (8). Insert two M3 x 14 mm screws (I) and secure.
(See Figure 11)
15. Align lock set (G) with holes in right door (9). Insert
two M3 x 14 mm screws from lock set and secure.
(See Figure 11)
16. Apply plastic bumper (K) to inside bottom corner of
doors. (See Figure 11)
Figure 11
8
G
I
I
9
8
9
K
1121 IH-6859
G
F