BGS technic 8343 Manual De Instrucciones página 4

PRODUCT FEATURES
Most popular pump design, engineered for professional use.
•
Premium powder coated steel pump.
•
Body with ribbed section.
•
• Aluminum die cast pump head for maximum strength.
Built-in bung for use on drums with either openings.
•
Steel lever handle with rubber grip for convenience.
•
• Wear resistant brass piston rings fitted onto zinc die cast piston.
•
With curved metal spout & telescopic suction tube.
TECHNICAL DATA
Suitable for barrel sizes 50 & 205 liter
Barrel bung thread: 1.1/2 inch & 2 inch
Delivery rate: up to 300 ml per stroke
Fluids: Heating oils, Motor oils, Diesel oil, Kerosene, Heavy & Light oils
Material: Steel / Aluminum / Zinc / Brass / NBR
ATTENTION
Read the operating instructions and all safety instructions contained therein carefully before using the
product. Use the product correctly, with care and only according to the intended purpose. Non-
compliance of the safety instructions may lead to damage, personal injury and to termination of the
warranty. Keep these instructions in a safe and dry location for future reference. Enclose the
operating instructions when handing over the product to third parties.
INDENDED USE
This pump is designed for a fast liquid transfer from 55 and 205 liter steel drums, for the liquids
mentioned in the chapter "Technical data", from the fields of agriculture, industry, mechanical
engineering, motor vehicle repair, etc.
SAFETY INFORMATIONS
• Keep the work area clean and dry. Damp or wet work areas can result in injury.
• When not in use, tools and equipment should be stored in a dry location to inhibit rust. Always
lock up tools and equipment, and keep out of reach of children.
• Use the right tool for the job. Do not attempt to force small equipment to do the work of larger
industrial equipment. Do not modify this equipment.
• Check for damaged parts. Before using this product, carefully check that it will operate properly
and perform its intended function. Check for damaged parts and any other conditions that may
affect the operation of this product. Replace damaged or worn parts immediately.
BEFORE INSTALLATION
• Eyes protection: Wear a protective mask or protective eyewear.
• Skin protection: Avoid repeated and prolonged contact of oils with the skin by wearing
impermeable protective gloves.
• Check that the equipment has not suffered any damage during transport or storage. Clean the
inlet and outlet openings, removing any dust or residual packing material.
• Do not smoke during refueling.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Oil Barrel Pump with Lever
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
BGS 8343
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed