Troubleshooting - Carson CY Pro Chassis Instrucciones

j. Troubleshooting
Please read this before something happens.
Engine won't start.
Engine flooded. Remove glow plug. Pull pull-start 6-8 times,
Too much fuel in
Beware of spraying fuel.
engine
GB
Dead glow plug Remove glow plug. Place glow plug in heater.
heater If the glow plug does not glow orange the plug
maybe dead. See also glow heater. (Wear gloves)
Dead glow Place new glow plug in heater. If it glows dim or
heater battery not at all, replace heater battery.
Engine stalls
Overheating Check temperature. If over 130 °C, richen carb
mixture. Check to make sure wheels spin freely.
Disconnected Reattach pressure line from exhaust pipe to fuel
fuel pressure tank lid.
line
Hard to control, "glitching"
Dead/weak Batteries in transmitter should be fully charged.
Slow servos mean dead receiver batteries.
batteries
Improper Refer to instructions on setting up your
transmitter transmitter
settings
Model doesn´t Transmitter or chassis power switch is not „ON"
move
Polarity or battery type is wrong
Batteries have run down
24 CARSON CY Pro Chassis
All manuals and user guides at all-guides.com
Empty fuel
tank/ No fuel in
engine
Overheating
Dirty air
cleaner
Carburettor
loose
Doesn´t run
straight
Doesn´t stop
Running too
slowly
Fill fuel tank. Prime engine by pulling pull-start
once while holding finger tip over muffler
(Wear gloves).
Running at high temperatures may cause vapour
lock. Let the car cool down for
10-15 minutes
Wash with soap and water, then use air filter oil
o
(N 50 003 2648).
Check carb-lock bolt and nut.
Press carb onto engine block, tighten nut to
prevent air leak.
Steering trim is not adjusted correctly
Front and rear wheel nuts are too loose
Throttle trim is not adjusted correctly
Motor has lost power
Rear wheel nuts are too loose
Dust or foreign objects are inside gears