Idle Speed Adjustment - Poulan Pro PP28CD Manual De Instrucciones

10. Insert the ends of the lines through exit
holes in the sides of the cover.
Line exit hole
11. Reinstall the spool and cover onto the
trimmer head. Push until cover snaps into
place.
All manuals and user guides at all-guides.com
REPLACING THE TRIMMER HEAD
1. Hold the dust cup with a wrench to keep
2. Remove trimmer head by turning coun-
3. Thread replacement trimmer head onto the

IDLE SPEED ADJUSTMENT

Cover
making idle speed adjustments. The trimmer
head or any optional attachment will be spin-
ning during most of this procedure. Wear your
protective equipment and observe all safety
precautions. After making adjustments, the
trimmer head or any optional attachment
must not move/spin at idle speed.
The carburetor has been carefully set at the
factory. Adjustment of the idle speed may be
necessary if you notice any of the following
conditions:
S Engine will not idle when the throttle is
S The trimmer
Make adjustments with the unit supported so
the cutting attachment is off the ground and
will not make contact with any object. Hold
the unit by hand while running and making ad-
justments. Keep all parts of your body away
from the cutting attachment and muffler.
To adjust idle speed:
Allow engine to idle. Adjust speed until engine
runs without trimmer head or any optional at-
tachment moving or spinning (idle too fast) or
engine stalling (idle speed too slow).
S Turn idle speed screw clockwise to increase
S Turn idle speed screw counterclockwise to
after each adjustment. The trimmer head or
any optional attachment must not move or
spin at idle speed to avoid serious injury to the
operator or others.
12
the shaft from turning while removing and
installing trimmer head.
Dust Cup
terclockwise (looking from bottom of
unit).
shaft by turning clockwise. Only tighten
hand tight!
WARNING:
Keep others away when
released.
head or
attachment moves/spins at idle.
engine speed if engine stalls or dies.
decrease engine speed if trimmer head or any
optional attachment moves or spins at idle.
WARNING:
Recheck the idle speed
any optional