Poulan Pro PP28CD Manual De Instrucciones página 5

WARNING:
Do not use trimmer head
as a fastening device for the blade.
WARNING:
The blade continues to
spin after the trigger is released or engine is
turned off. The coasting blade can throw ob-
jects or seriously cut you if accidentally
touched. Stop the blade by contacting the
right hand side of the coasting blade with ma-
terial already cut.
CAUTION:
If received assembled, repeat
all steps to ensure your unit is properly as-
sembled and all fasteners are secure.
Examine parts for damage. Do not use dam-
aged parts.
NOTE:
If you need assistance or find parts
missing or damaged, call customer support.
It is normal for the fuel filter to rattle in the
empty fuel tank.
Finding fuel or oil residue on muffler is normal
due to carburetor adjustments and testing
done by the manufacturer.
INSTALLING TRIMMER ATTACH-
MENT
CAUTION:
When installing trimmer attach-
ment, place the unit on a flat surface for stabil-
ity.
1. Loosen the coupler by turning the knob
counterclockwise.
Coupler
Shipping
protector
TIGHTEN
All manuals and user guides at all-guides.com
starting unit. Remove all debris and hard ob-
jects such as rocks, glass, wire, etc., that can
ricochet, be thrown, or otherwise cause injury
or damage during operation.
S Throw away and replace blades that are
S Install required shield properly before using
S Use only specified blade and make sure it is
S Cut from your left to your right. Cutting on
S Always use the handlebar and a properly
ASSEMBLY
2. Remove shipping protector from coupler.
3. Remove the shaft cap from the trimmer
4. Position locking/release button of attach-
5. Push the attachment into the coupler until
6. Before using the unit, tighten the knob se-
release button is locked in the primary hole
and the knob is securely tightened before op-
erating the unit. All attachments are designed
to be used in the primary hole unless otherwise
LOOSEN
stated in the applicable attachment instruction
manual. Using the wrong hole could lead to seri-
ous injury or damage to the unit.
Knob
5
WARNING:
Inspect area before
bent, warped, cracked, broken or damaged
in any other way.
the unit.
properly installed and securely fastened.
the right side of the shield will throw debris
away from the operator.
adjusted shoulder strap with blade (see AS-
SEMBLY instructions in brushcutter attach-
ment instruction manual).
attachment (if present).
ment into guide recess of coupler.
the locking/release button snaps into the
primary hole.
curely by turning clockwise.
Coupler Primary Hole
Locking/
Upper
Release
Shaft
Button
WARNING:
Make sure the locking/
Guide Recess
Attachment