Sauder 415542 Instrucciones De Montaje página 8

Step 4
Position one of the BACKS (G) over the upper portion of your unit.
å
Make equal margins along all four edges of the BACK (G). Push on
å
opposite corners of your unit if needed to make it "square".
Fasten this BACK (G) to the upper portion of your unit using the
å
NAILS (R). The NAILS should be approximately 5" apart, 1-1/2" from
the corners, and 1/4" in from the edges.
NOTE: Do not tap nails into the bottom edge of this BACK at
å
this time.
Fasten the remaining BACK (G) to the lower portion of your unit
å
using the NAILS (R).
IMPORTANT: The NAILS along the bottom edge of the lower BACK
å
should be 11/16" from the edge of the BACK. Cut out and use the
"spacer" at the top of this page for the correct location.
These holes must line up
over the FIXED SHELF (F).
Page 8
Do not fasten NAILS along this
edge until the lower BACK is
overlapping the upper BACK.
G
11/16"
spacer
11/16"
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
Fasten the upper
BACK (G) fi rst.
G
approximately 5"
415542
R
NAIL
(48 used in this step)
1-1/2"
1/4"
www.sauder.com/services