Duronic JE7C Manual De Instrucciones página 7

• Ensure power supply is suitable for the rated voltage of the machine.
• Ensure that all parts are clean and dry before assembling together.
• Always ensure the juicer is stood on an even, stable, clean and dry
surface.
• Before using fruit, run the motor for 5 seconds to test it all works fine.
On first use, because the motor is new, there may be a slight peculiar
smell and/or spark. Please know that this is normal and after the
motor works for a short period of time the above phenomenon will
disappear.
• During juicing, make sure that the middle ring does not get too full
with juice and pulp. If it is too full turn off the power supply, empty and
clean the middle ring. Then reassemble to continue using.
• During use, do not open the handle or transparent cover.
• For your own safety, ff the power supply is on do not put your hand or
anything other than food into the feed port. If you try to put anything
other than fruit/vegetables into the juicer injury may occur or the
machine could be damaged. Always use the pushing bar.
• When using the pushing bar ensure you push the fruit/vegetables in
using a consistent force and steady speed.
• In order to prolong the life of this machine an over-heating protective
element has included in the motor. If the motor works for a long
time or goes over the 'warning temperature', the power supply will
automatically cut off. If this happens, after the motor stops pull out
plug of power supply and wait for the motor to cool (about for 30 min)
before using again.
• Do not overload the juicer.
During operation do not leave children unattended with the
machine. Supervision is required at all times.
BEFORE JUICING
DURING JUICING
7