Duronic PS991 Manual De Instrucciones página 7

enough time to remove any excess paper from the cutters and limit any paper
from the wastevbasket being fed back into the shredder cutters.
3. The Power Button is used to terminate the AC power to the shredder. It is
recommended to turn the shredder off when the shredder is not being used for
a prolonged period of time.
4. The ready LED will light up if machine is power on.
When manually changing the direction of the cutters, pause long enough for
the motor to stop to avoid any damage to the motor.
Shredder capacity:
The machine will shred up to 18 sheets of paper and will accept paper widths
up to 220 mm. When shredding small material like envelopes or credit card
receipts, insert them in the middle of the feed opening.
Note:
The mechanism should be oiled regular after a certain operating time to
maintain the cutting performance.
This can be easily accomplished if you pour special shredder oil on a sheet of
paper and feed it through the inlet guide to the cutting mechanism
1. Keep all loose articles of clothing, ties, jewelry, hair, or other small items
away from the feed opening to prevent injury.
2. Keep the shredder turned off or unplugged when not in use for prolonged
periods of time.
3. Remove all paper clips and staples from paper before shredding. The
machine will cut staples; however, it is not recommended.
4. Do not place hands or fingers into the shredder throat as serious injury
could result.
5. When manually changing feed direction, pause long enough for the motoor
to stop.
6. Continuous shredding paper should not exceed 20 minutes. If continuous
use is required at the maximum sheet capacity(18 sheets), it is recommend
that shredding time should be 20 minutes on and 40 minutes off to allow for
proper cooling of the motor.
7. Always turn off or unplug the shredder prior to moving, cleaning or emptying
the wastebasket.
Cautions
7