AmazonBasics G5W Manual De Instrucciones página 6

• Plug the nano receiver into the USB port on your computer.
• Set the ON/OFF switch (J) on the bottom side of the mouse
to ON.
• The LED indicator (G) flashes steadily when the product is in
pairing mode and stops blinking when it is successfully paired
with the receiver.
NOTE
• Remove the nano receiver from the computer's USB port and
plug it back in. Press the Connect button (I) at the bottom of
the mouse.
• If the product does not work after 10 seconds, pair it again.
Operation
Track ball (A)
• Spin the track ball to move the cursor on the computer screen.
DPI button / LED indicator (G)
• The LED indicator blinks steadily:
The mouse is pairing. The LED indicator turns off after pairing
successfully.
• The LED indicator flashes for 10 seconds:
Low battery warning.
• The LED indicator also indicates the DPI setting in use. There
are 3 different settings:
Blink 1: 600 DPI
Blink 2: 800 DPI
Blink 3: 1000 DPI
The default setting is 800 DPI. Press the DPI button to switch
between the settings. In order to save power, the LED switches
off after 10 seconds.
6
The receiver has an auto pairing function. If the
connection between the mouse and the receiver
fails or is interrupted, proceed as follows: