Model Differentiation; Unit Setup - Toshiba RBC-RD1-PE Instrucciones De Instalación

All manuals and user guides at all-guides.com
K7046 Combined Installation

Model Differentiation

G
There are two models available, the first is RBC-RD1-PE. The RD1 is designed to be
installed next to the indoor unit, with the remote sensor and audible alarm located at
a low level and preferably under the indoor unit.
G
The RD1 is designed for use with MMS indoor units and RAV '4' Series AI indoor
units only.
G
The second model is the RBC-RD2-PE. The (RD2) is designed for use in the modular
multi outdoor unit. The unit will be located within the compressor housing, and it has
an internal sensor.
G
The RD2 can only be fitted to the MMS outdoor unit.
G
The functionality of both systems will be covered in indoor & outdoor operation
section of this manual.
G
There are two control PCB's inside the leak detector, each with jumpers which enable
specific functions to be enabled/disabled. The diagrams below show the locations of
these jumpers.
+ sig – mute + buzzer
6/3/01 8:37 am Page 6
GB

Unit Setup

AI ALARM
N L
control board
A B C
JP
Sub PCB
6