Denver DAB-35 Manual Del Usuario página 2

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 25
DENVER DAB-35
PARTS
Front view
1. SPEAKER
2.
STANDBY BUTTON
3. MODE BUTTON
4. LCD DISPLAY
5. TUN/CH▼ BUTTON
6. TUN/CH▲ BUTTON
7. ALARM/SNOOZE BUTTON
8. MENU/INFO BUTTON
9. VOLUME CONTROL
SWITCHING YOUR RADIO ON FOR THE FIRST TIME
AC Operation
1.
Insert the DC power jack of AC/DC adaptor to the DC input socket located at the rear of the
radio.
2.
Plug the AC/DC Adaptor to the AC mains outlet.
3.
Press the
STANDBY to turn the radio on.
Remarks: If the AC Adaptor voltage is over than 6V, it will possible make the line damage.
DC (battery) operation
1.
Ensure the AC/DC adaptor is disconnected from the radio and AC mains.
2.
Installed the batteries (4×1.5V UM3/AA battery) into the battery compartment.
3.
Press the
STANDBY to turn the radio on.
Remarks: To obtain the best performance in DC operation, the use of alkaline batteries is highly
recommended.
Menus:
The following controls are used to move about the menu tree to choose and select the required
settings:
Press and hold MENU/INFO button to enter into the "MENU". Press the TUN/CH▲ or TUN/CH▼
button to navigate the desire option, then press SELECT button to confirm.
Rear view
No function
10. SELECT BUTTON
11. PRESET BUTTON
12. ROD ANTENNA
13. DC INPUT SOCKET
14. RATING LABEL
15. HEADPHONE JACK
16. BATTERY DOOR
17. AC/DC ADAPTOR
ENG-1
MENU Tree as below:
Mode
DAB
Menu
DAB Menu
Full Scan
Manual Tune
Prune
System
17
Time Menu
Set Time/Date
Auto Update
Set 12/24 hour
Set Date Format
BASIC OPERATION - GETTING STARTED
STANDY button to turn the unit on, it will automatically enter into the DAB mode and
Press the
perform auto scan function. During the scan, the display show "Scanning..." together with a slide bar
that indicates the progress of the scan and the amount of stations that have been found so far. (F.2)
Once the scan has finished, the radio will select the first alphanumerically found station. You can
now press ▼/▲ buttons to explore the found stations followed by pressing the SELECT button to
select listening to the stations.
Note: If there is no stations found after auto scan, the radio will display "Full Scan", you can now
press ▼/▲ buttons to select "Full scan" or "Manual tune" for stations, and press SELECT button to
finally confirm.
F.1
DENVER DAB-35
Mode
FM
Menu
FM Menu
Scan Setting All station/Strong stations only
Audio Setting Stereo Allowed/Forced mono
System
System Menu
Sleep Menu
Time
Sleep
Sleep
Backlight
Factory Reset
Backlight Menu
SW version
Backlight Low/ Medium/ High
hh:mm/DD-MM-YYYY
Update from Any/Update from DAB/Update from FM/ No Update
12/24
DD-MM-YYYY/MM-DD-YYYY
F.2
ENG-2
Off /10/20/30/60/70/80/90minutes

Publicidad

Tabla de contenido
loading

Tabla de contenido