Operation; General; Lifting Loads; Releasing Loads - probst FXAH-120-GRABO-GREENLINE Instrucciones De Uso

Operation

4 Operation
4.1

General

•
Do not tear off stuck loads.
•
In the event of a power failure, immediately disconnect the load if possible.
•
Only suck in and lift suitable loads (check inherent stability and surface density).
•
Only place the load on a free, level surface. Otherwise they can slip when released.
•
Do not release the load until it is completely and securely supported or standing.
•
Keep hands away from the load when releasing.
•
Always load the suction surfaces evenly.
4.1.1

Lifting loads

•
Position the device directly above the load.
•
Place the device on the load. Ensure even load distribution.
•
The load is now sucked in.
•
When lifting, make sure that only one piece of the material to be lifted is lifted at a time. Carefully
remove any other adhering parts with a screwdriver before you lift the part further. Do not loosen
with your hands, danger of crushing!
4.1.2

Releasing loads

•
Lower the load and lay it down safely on a free, flat surface so that the load cannot slip or tip over.
•
Press the red release button to release the sucked load.
•
Load is now released.
58500016 10 / 16 GB