Olymp LavaSit PURE Instrucciones De Servicio página 7

e. Cleaning ceramic parts
·
Rub dry with a soft cloth or microfibre cloth.
·
Stubborn spots and calcified deposits should be removed using a mild cleansing agent.
·
On no account should abrasive cleansers or solvents be used!
2. Comfort chair
a. Chair with electrically swivelling leg-support
·
The leg-support (Fig. 3) is operated by means of the 2-key remote control (Fig. 8).
·
Move the leg-support upwards by means of the 5-key.
·
Move the leg-support downwards by means of the 6-key.
·
The remote-control unit is secured magnetically to the right-hand side of the seat. (Fig. 3)
Important user information for remote control:
The wash-basin remote control unit is designed exclusively for the use of clients with dry
hands.
To guarantee correct operation of the electronic components, the remote control unit
must in no circumstances be allowed to come into contact with water, shampoo or other
fluids.
If it is operated with hands covered in foam, or with dirty hands, the remote control unit will not operate
correctly, there will be lasting damage to the electrical components, and the keys may become
permanently soiled.
The guarantee does not cover damage to the electronics as a result of the effects of
wetness!
If, in exceptional circumstances, stylists need to operate the remote control themselves, it is essential
that the plastic cover be used.
3. Substructure
The water installations and angle valves are located in the substructure.
Please Note:
> We recommend to provide the supply lines with a central shut-off device.
> If the system is operated without a suitable shut-off device, the angle valves must be closed at the
end of business hours.
a. Inspection rear panel (Fig. 6)
· To open the panel, slacken the hexagon socket fixing screws left and right by means of the
hexagon socket key supplied, and remove the panel.
WARNING: Always isolate the complete system and secure against unintended
switch-on before opening the inspection cover!
· To fasten the panel in place, tighten the fixing screws again with the hexagon socket key.
b. Cleaning instructions for plastic surfaces
· The plastic surfaces of the substructure should be cleaned with a damp cloth or microfibre cloth –
or, if necessary, using a mild cleansing agent.
· On no account should abrasive cleansers or solvents be used!
· Please ensure that spots of various hair chemical agents (above all directly applied colouring
agents) do not fall on the plastic surfaces, as these cannot be removed.
GB
2