HAMPTON BAY EF200SQ-52 Guía De Uso Y Mantenimiento página 7

Assembly - Standard Ceiling Mount
1
Preparing for mounting
□
Remove the canopy ring (D) from the canopy (C) by
turning the ring counter-clockwise until it unlocks.
□
Remove the mounting bracket (A) from the canopy (C)
by loosening the two canopy screws (FF) located in the
"L shaped" slots.
□
Remove and save the two canopy screws (FF) and lock
washers (GG) in the round holes. This will enable you to
remove the mounting bracket (A).
A
C
D
3
Assembling the fan
CAUTION: To ensure wobble-free operation and to
avoid damage to the fan, the downrod (B) and the
setscrew (RR) must be completely tightened
□
Remove the setscrew (RR) by turning it counterclockwise.
□
Install the downrod (B) by inserting it into the motor collar
(TT), and turning it clockwise until it is tight.
□
Reinstall the setscrew (RR) turning clockwise until tight.
2
Routing the wires
□
Route the wires exiting the top of the fan motor (F),
through the coupler cover (E), and canopy ring (D).
□
Make sure the slot openings are on top and route the
wires through the canopy (C) and then through the
ball/downrod assembly (B).
GG
FF
7
C
D
E
B
F
C
D
E
B
TT
F
Please contact 1-855-HD-HAMPTON for further assistance.
RR
HAMPTONBAY.COM