Sony SDM-S53 Manual Del Usuario página 41

Symptom
Picture is fuzzy
Picture is ghosting
Picture is not centered or sized
properly
Picture is too small
Picture is dark
Wavy or elliptical pattern (moire)
is visible
Color is not uniform
White does not look white
Monitor buttons do not operate
( appears on the screen)
The monitor turns off after a while
After turnig off the main power,
the 1 (power) indicator stays
bright for a while
Check these items
• Adjust the brightness and contrast (page 11).
• Adjust the pitch and phase (page 12).
x Problems caused by a computer or other equipment connected, and not
caused by the monitor
• Set the resolution to 1024 × 768 (SDM-S53), 1280 × 1024 (SDM-S73/S93) on your
computer.
• Eliminate the use of video cable extensions and/or video switch boxes.
• Check that all plugs are firmly seated in their sockets.
• Adjust the pitch and phase (page 12).
• Adjust the picture position (page 13). Note that some video modes do not fill the screen to
the edges.
x Problems caused by a computer or other equipment connected, and not
caused by the monitor
• Set the resolution to 1024 × 768 (SDM-S53), 1280 × 1024 (SDM-S73/S93) on your
computer.
• Adjust the backlight (page 11).
• Adjust the brightness (page 11).
• Adjust the gamma using "Gamma" (page 14).
• It takes a few minutes for the display to become bright after turning on the monitor.
• The screen might turn darker, depends on ECO mode you selected.
• Adjust the pitch and phase (page 12).
• Adjust the pitch and phase (page 12).
• Adjust the color temperature (page 13).
• If "MENU LOCK" is set to ON, set it to OFF (page 14).
xProblems caused by the connected computer or other equipment
• Set the computer's power saving setting to off.
• When the main power is on but the 1 (power) switch is not pressed, or when the monitor
is in the power saving mode, if you turn the MAIN POWER switch off, the 1 (power)
indicator may not turn off right away. This is not a malfunction.
GB
(continued)
19