Troubleshooting; On-Screen Messages - Sony SDM-S53 Manual Del Usuario

Horizontal frequency: 28–61 kHz (SDM-S53)
28–80 kHz (SDM-S73/S93)
Vertical frequency: 48–75 Hz
Consequently, the first time the monitor receives input signals
that do not match one of the factory preset modes, the monitor
may take a longer time than normal to display the picture on the
screen. This adjustment data is automatically stored in memory so
that next time, the monitor will function in the same way as when
the monitor receives the signals that match one of the factory
preset modes.
If you adjust the phase, pitch, and picture position
manually
For some input signals, the automatic picture quality adjustment
function of this monitor may not completely adjust the picture
position, phase, and pitch. In this case, you can set these
adjustments manually (page 12). If you set these adjustments
manually, they are stored in memory as user modes and
automatically recalled whenever the monitor receives the same
input signals.
Note
While the automatic picture quality adjustment function is activated, only
the 1 (power) switch will operate.
The picture may flicker during this time, but this is not a malfunction.
Simply wait a few moments until the adjustment completes.
16

Troubleshooting

Before contacting technical support, refer to this section.

On-screen messages

If there is something wrong with the input signal, one of the
following messages appears on the screen. To solve the problem,
see "Trouble symptoms and remedies" on page 18.
If "OUT OF RANGE" appears on the screen
This indicates that the input signal is not supported by the
monitor's specifications. Check the following items.
For more information about on-screen messages, see "Trouble
symptoms and remedies" on page 18.
If "xxx.x kHz/xxx Hz" is displayed
This indicates that either the horizontal or vertical frequency
is not supported by the monitor's specifications.
The figures indicate the horizontal and vertical frequencies of
the current input signal.
I NFORMA T I ON
OUT OF RANGE
x x x . x k H z /
If "RESOLUTION > 1024 × 768" is displayed
(SDM-S53)
This indicates that the resolution is not supported by the
monitor's specifications (1024 × 768 or less).
If "RESOLUTION > 1280 × 1024" is displayed
(SDM-S73/S93)
This indicates that the resolution is not supported by the
monitor's specifications (1280 × 1024 or less).
I NFORMA T I ON
OUT OF RANGE
RESOL UT I ON >
If "NO INPUT SIGNAL" appears on the screen
This indicates that no signal is being input.
I NFORMA T I ON
NO I NPUT S I GNA L
GO TO POWER SAVE
"GO TO POWER SAVE"
The monitor will enter the power saving mode after about 5
seconds from the time the message is displayed.
x x x H z
1 8 0 X 1 . 2 0 2 4