Orbegozo PHF25 Manual De Instrucciones página 13

PHF 25
indispensable, they must conform to existing safety standards and their current capacity
(amperes) must not be less than the maximum of the appliance.
• Position the heater:
- So it is horizontal, to avoid it overheating or damaging the heating elements.
- Far from other sources of heat, inflammable materials (curtains, carpets, etc.), inflammable
gases or explosive materials (spray cans) and from materials that can deform on exposure to
heat.
- at the minimum distances from walls (always so long as they are masonry or brick) indicated
in figure n.2; these distances must be increased at least 3 times for other materials, but it is a
good idea to use a professionally qualified installer.
- Not below electrical outlets.
• Attach the heater to the wall using the screws provided (the lower one can be covered with
the cap provided).
• Make sure that the electric cord is correctly positioned, not touching hot or sharp surfaces
and not wrapped around the appliance or twisted.
• To orient the infrared radiant element and heat in the most convenient way, adjust the
inclination of the heating part (angle = 45° max).
• In the event of a fault or poor operation switch the appliance off and have it checked by
professionally qualified personnel.
25CM
OPERATION
The heater has a "pull switch" to select the heater's power with a display that shows the
selection: 0 = off, 1 = 650W, 2 = 1350W and 3 = 2000W. The selection changes each time you
pull the cord.
To turn the heater off, pull the cord of the "pull switch" until you see "0" on the display.
CLEANING AND MAINTENANCE
• Before cleaning the appliance, switch it off, remove the plug from the current socket and
leave it until getting cool.
• Protect the radiant part from dust to preserve its reflectivity.
30CM
25CM
180CM
13