VR46 KD1 Manual Del Usuario página 6

• Before using the scooter for the first time, fully charge the battery.
• Press the power button for a few seconds to start it.
• Check the battery indicator: if the battery is dead, charge it before use. The electric scooter is a device
that needs to be charged periodically to be able to work.
• Check the tyre pressure (36PSI); if the scooter does not reach at least 60% of the declared Km or does
not reach the maximum speed within the first 3 months of use, it is likely that the wheels have deflated
again. In this case, restore the pressure as indicated.
• Place the scooter on a flat surface
• Place your hands on the handlebars. Step onto the footrest with one foot and use the other to give
yourself a gentle push and accelerate.
IMPORTANT
The accelerator is activated once the speed of travel exceeds 3 km/h.
For safety reasons, the scooter is initially set up to avoid standing starts.
• When the scooter begins to move, place both feet on the footrest and press the accelerator.
• To steer the scooter, tilt your body in the direction of travel when turning and slowly turn the
handlebar.
• To stop the scooter, release the accelerator and press the electronic brake or lever on the left side
of the handlebar.
• To get off, stop the scooter completely first. Trying to get off a moving scooter may result
in injuries.
• To change speed mode, press the up/down arrow button (chapter 5).
• When riding at night or in dark places, press the power button once to turn on the lights, wear a
reflective vest.
For your own safety, wear a helmet and knee pads to protect yourself against falls and injuries
while learning to ride the electric scooter.
The rider assumes all responsibility for any injury suffered when not wearing a helmet or other
protective gear.
2. Quick guide
04