Time Setting - Toshiba RBC-SRC-PE Manual Del Usuario

All manuals and user guides at all-guides.com
R
EMOTE
T
IME
The main Isolation Switch needs to be set to the "ON" position (the operation lamp flashes).
Before operating the air conditioner, set the
present time in the following sequence. (The
air conditioner can be operated without the
present time being set, but once it has been
set timer operations can be used and the time
display will also serve as a clock.)
Provided that the power switch is ON or the
back-up batteries have been installed in the
remote controller, the present time will be
indicated at all times regardless of whether
the air conditioner is operating or not.
The 24-hour system is used to indicate the
time. Thus, "13:00" is indicated at 1 o'clock in
the afternoon.
The clock has an accuracy which is equivalent
to a monthly error of less than 60 seconds.
1. Each time the TIME ADJUST switch is
pressed, the displays flash in the following
sequence:
CLOCK ON TIME OFF TIME.
Example: CLOCK 12:00
Make the above display flash.
GB
C
ONTROLLER
S
ETTING
Set the required time while the display is
flashing in each mode.
- +
2. Press the switches to set the time.
When given one press at a time, these
switches will change the time in 1-minute
units; when kept depressed, they will change
in 10-minute units.
3. Press the TIME ADJUST switch again and set
the CLOCK display. The setting is completed
when the flashing stops.
The flashing automatically stops after
approximately 15 seconds if no key is pressed
even if step 3 is not taken, and an adjusted
CLOCK display will appear.
The ON TIME and OFF TIME represents the
times at which the air conditioner will be started
and stopped automatically by the timer. As with
the CLOCK, make the ON TIME and OFF TIME
flash to set the times.
– 9 – – 9 –