Preparing To Use The Booster; Booster Location; Installation Instructions; Features - DSR DSR100 Manual Del Usuario

3. PREPARING TO USE THE BOOSTER

IMPORTANT: AFTER PURCHASE,
CHARGE YOUR BOOSTER FOR
24 HOURS, BEFORE USE.
WARNING! RISK OF CONTACT WITH
BATTERY ACID. BATTERY ACID IS A
HIGHLY CORROSIVE SULFURIC ACID.
3.1 Be sure the area around the battery is well
ventilated while the booster is being used.
3.2 Clean the battery terminals before using
the booster. During cleaning, keep
airborne corrosion from coming into

4. BOOSTER LOCATION

WARNING! RISK OF EXPLOSION
AND CONTACT WITH BATTERY ACID.
4.1 Locate the booster as far away from the
battery as the DC cables permit.
4.2 Never place the booster directly above

5. INSTALLATION INSTRUCTIONS

5.1 Remove all cord wraps and uncoil the cables
prior to using the charger and booster.

6. FEATURES

1 2 3
6.1 Charger LED Indicators
POWER (green) LED lit: The
charger is connected to AC power.
CHARGING INDICATOR
Yellow/orange LED lit: The charger
is charging the battery.
Yellow/orange LED flashing:
The charger is in abort mode.
Green LED pulsing: The battery
is fully charged and the charger
is in maintain mode.
All manuals and user guides at all-guides.com
1. Battery clamps
4 5
2. Circuit breaker for
3. 12 Volt DC power outlet
4. Voltmeter
• 6 •
contact with your eyes, nose and mouth.
Use baking soda and water to neutralize
the battery acid and help eliminate
airborne corrosion. Do not touch your
eyes, nose or mouth.
3.3 Determine the voltage of the battery by
referring to the vehicle owner's manual
and make sure that the output voltage of
the booster is correct.
3.4 Make sure that the booster cable clips
make tight connections.
the battery being jumped; gases from
the battery will corrode and damage the
booster.
4.3 Do not operate the booster in a closed-in
area or restrict the ventilation in any way.
5.2 After purchase, charge your booster for
24 hours, before use.
5. Voltmeter button
6. SC2DSR charger
12V DC power output
7. Charging status LED
and charge port
8. Power LED
9. 12V DC adaptor
and charge port
6
7
8
CLAMPS REVERSED (red)
LED flashing: The connections
are reversed.
BAD BATTERY (red) LED lit:
The charger has detected
a problem with the battery. See
Troubleshooting for more information.
(not shown)