Maintenance Instructions; Moving And Storage Instructions - DSR DSR100 Manual Del Usuario

Fuse specification
AMG Heavy Duty 300A
WARNING! KEEP AWAY FROM SPARKS
AND FLAMES – BATTERY COULD EMIT
EXPLOSIVE GASES.
1. Allow the fuse to cool down
completely (approximately 5 minutes).
2. Make sure the unit is unplugged from
the external charger.
3. Open the back cover to expose the
battery and the fuse.
4. Using a wrench, remove the first nut
and bolt securing the fuse on the
battery. Repeat the same steps for
the second nut and bolt. Remove the
open fuse and replace it with a new
one of the same type and rating.
5. Tighten the nuts and bolts to secure
the fuse, and then replace the cover.
6. The unit is now ready to use.

9. MAINTENANCE INSTRUCTIONS

9.1 After use and before performing
maintenance, unplug and disconnect the
booster.
9.2 Use a dry cloth to wipe all battery corrosion
and other dirt or oil from the battery clips,
cords, and the booster's case.

10. MOVING AND STORAGE INSTRUCTIONS

10.1 IMPORTANT:
• CHARGE IMMEDIATELY AFTER
PURCHASE
• KEEP FULLY CHARGED
The internal battery will gradually
self-discharge (lose power) over time,
especially in warm environments. Leaving
the battery in a discharged state may
result in permanent battery damage.
10.2 Store inside, in a cool, dry place.
The ideal storage temperature is between
50°-77°F (0°-25°C).
All manuals and user guides at all-guides.com
8.3 Powering a 12V DC Device:
9.3 Ensure that all of the booster's
9.4 All servicing should be performed by
10.3 Clamps must be stored on their support
10.4 If the booster is moved around the shop
• 9 •
The booster is a power source for all 12V
DC accessories that are equipped with
a 12V accessory plug. Use it for power
outages and fishing or camping trips.
1. Make sure the device to be powered
is OFF before inserting the 12V DC
accessory plug into the 12V DC
accessory outlet.
2. Open the protective cover of the DC
power outlet on the front of the booster.
3. Plug the device into the outlet and turn
the device on (if required).
4. If the device draws more than 16A
or has a short circuit, the internal
circuit breaker of the booster will
trip and disconnect the power to
the device. Disconnect the device
and manually reset the breaker by
pressing the red button.
IMPORTANT: The DC power outlet is
wired directly to the internal battery.
Extended operation of a 12V device may
result in excessive battery drain. Recharge
immediately after unplugging the device.
components are in place and in good
working condition, including the plastic
boots on the battery clips.
qualified service personnel.
posts, to make sure they do not come to
contact with any metallic surface.
or transported to another location, take
care to avoid/prevent damage to the
cords, clips and the unit. Failure to do so
could result in personal injury or property
damage.
IMPORTANT: Do not use and/or store
the booster in or on any area or surface
where damage could occur if the internal
battery should unexpectedly leak acid.