Wolf ICBCT15I/S Instrucciones De Instalación Y Funcionamiento página 14

W O L F
U N F R A M E D
Flush mount installations are intended
for granite, solid surface or stone coun-
tertop surfaces only. Failure to use high
heat resistant surface will result in coun-
tertop damage if hot cooking utensils are
accidentally moved off the cooking
surface.
M O D E L S I C B C T 3 0 I U A N D I C B C T 3 6 I U
Unframed induction cooktop Models
ICBCT30IU and ICBCT36IU can be mounted
flush with the top of the countertop or as a
frameless installation with the glass mounted
on top of the countertop surface.
IMPORTANT NOTE: The materials required
for a flush mount installation are provided with
the unframed Models ICBCT30IU and
ICBCT36IU. Refer to the instructions provided
with the unframed cooktop installation kit
(# 811358) for additional specifications.
14
All manuals and user guides at all-guides.com
I N D U C T I O N C O O K TO P S
I N S TA L L AT I O N S
F L U S H M O U N T I N S TA L L AT I O N
There are two options for a flush mount
installation of the unframed induction cooktop;
Option 1 and Option 2.
OPTION 1: For this flush mount installation, a
recessed area surrounding the standard coun-
tertop cut-out is required. Fabrication of the
recessed area must take place before the final
countertop installation. A template of the coun-
tertop cut-out is provided with the unframed
cooktop for fabrication purposes.
IMPORTANT NOTE: This fabrication method is
not recommended for molded backsplash style
countertops (triple cove).
For countertop cut-out dimensions, refer to
the Installation Specifications illustration on
page 12 for Model ICBCT30IU and page 13 for
Model ICBCT36IU.
In order to rout the required recessed area for
this flush mount installation, a second
template must be made from 13 mm plywood.
The template will be used as a guide for a top
bearing router bit.
Make the wood template wide enough so that
clamps used to hold this template to the coun-
tertop do not interfere with the router base.
The cut-out dimension of the wood template
should match the outer perimeter of the
template supplied with the cooktop.
Center the wood template over the existing
cut-out in the countertop and clamp. It may be
helpful to use medium-strength double-sided
tape to adhere the template to the countertop;
this will keep the template from shifting during
the routing operation. Make sure that the
adhesive can be easily removed by testing it
on a scrap piece of the countertop. Using a top
bearing router bit with the wood template as a
guide, rout out a 8 mm deep recessed area in
the countertop cut-out.