Wolf ICBCT15I/S Instrucciones De Instalación Y Funcionamiento página 18

W O L F
C O O K T O P
Attach the foam strip to the underside of the
cooktop frame. Refer to the illustration below.
IMPORTANT NOTE: For unframed installation,
adhere foam strip to the outer edge of the
glass, not the support frame.
A C C E S S O R I E S
Gently lower the cooktop into the cut-out area
in the countertop and center. Check that the
Optional acces-
front edge of the cooktop is parallel to the
sories are available
front edge of the countertop. Check that all
through your
required clearances are met.
Wolf dealer. To
obtain local dealer
Attach the brackets to the bottom of the unit,
information, visit
as shown in the illustration below. Install the
our website,
clamping screws into the bracket and tighten
wolfappliance.com.
until the screws contact the underside of the
countertop. Do not overtighten the screws.
IMPORTANT NOTE: Do not seal the cooktop
to the countertop. It must be removed if
service is necessary.
If the ceramic glass top of the cooktop is
broken, turn off power to the unit. Do
not operate until glass has been replaced
by a Wolf authorized service center.
18
All manuals and user guides at all-guides.com
I N D U C T I O N C O O K TO P S
I N S TA L L AT I O N
COOKTOP
Foam strip
B E F O R E O P E R AT I N G
Clean the ceramic glass surface carefully using
the Cooktop Cleaning Crème provided with the
cooktop. Remove all cleaning residue.
Read the entire Wolf Induction Cooktops
Use & Care Information included with the
cooktop. Important safety and service informa-
tion is contained within the book.
C O O K T O P R E M OVA L
IMPORTANT NOTE: This procedure should
only be performed by a Wolf authorized
service center.
If it is necessary to remove the cooktop for
cleaning or service, disconnect the electrical
supply. Remove the mounting brackets on the
right and left side of the unit and remove the
cooktop. Reinstall in the reverse order.
IMPORTANT NOTE: For flush mount installa-
tions, use a razor blade to cut around the RTV
seal. A new RTV installation kit (811358) will be
required to reinstall the cooktop. This kit is
available through your Wolf dealer. To obtain
local dealer information, visit our website,
wolfappliance.com.
COOKTOP
FOAM
BRACKET
STRIP
BRACKET
SCREWS
Installation brackets
COUNTERTOP
89 mm
CLAMPING
SCREW