Troubleshooting; Operating Messages; Error Codes - VWR MCP 100 Manual De Instrucciones

Hı
Lo
btLo
Store Date
Cal
RESULT
Time Cal
E27 / E28 / E29
E 10 / E 11
E 20 / E 21
E23 / E24 / E25
E 22
E 70
E 71
E 72
E 73
E 74
E 75
E 76
E 77
26

Troubleshooting

Operating messages

Measuring range exceeded or excessive turbidity.
Result below the lowest limit of the measuring range.
Replace batteries, no further tests possible.
Battery capacity is too low for the display backlight;
measurement is still possible.
A user calibrated method is indicated by an arrow while the test result
is displayed (see "Factory calibration reset").

Error codes

Light absorption too great. Reasons: e.g. dirty optics.
Calibration factor "out of range"
Too much light reaching the detector.
Too much light reaching the detector.
Battery capacity was too low during measurement. Change battery.
CL 3.5: Factory calibration incorrect / erased
CL 3.5: User calibration incorrect / erased
CL 8: Factory calibration incorrect / erased
CL 8: User calibration incorrect / erased
O 3: Factory calibration incorrect / erased
O 3: User calibration incorrect / erased
CLO2: Factory calibration incorrect / erased
CLO2: User calibration incorrect / erased
VWR ver 1 23.01.2018