Beurer PureSkin Pro Instrucciones De Uso página 31

Warning to sunbathers before and after treatment!
Sunbathing before treatment
1. After sunbathing, wait at least 2 weeks before using the device.
2. Before treatment, check the skin for signs of sunburn. If you have sunburn
that has not healed, wait until it has completely healed to use the device.
3. Carry out a skin sensitivity test on the tanned skin (see section 5.1) to determine which
energy intensity is right for you.
Sunbathing after treatment
1. After treatment, wait at least 48 hours before sunbathing. Skin that is still reddened must
be kept out of the sun.
2. For the first two weeks after the treatment, the treated skin must be covered with clothing
or sunblock (at least SPF 30) when you are out in the sun.
Tanning with artificial light
The instructions for "sunbathing before treatment" and "sunbathing after
treatment" also apply to tanning using an artificial light and tanning lotion.
Do not use the device 24 hours before or after using a sauna/swimming pool, as the
chlorine may lead to skin irritation.
IMPORTANT
To prevent damage
• Do not attempt to open or repair your device. Attempting to open the device may damage
it and invalidates your warranty.
• The device should never be left unattended when it is plugged into a socket.
• Do not operate the device if the device itself, a cable or a plug is damaged and keep the
mains cable away from hot surfaces.
• Always unplug the device from the mains immediately after use.
• Do not use the device with attachments or accessories that are not recommended by
beurer GmbH.
• During use, do not expose the device to temperatures below 10 °C or above 35 °C.
• Do not use the device if you see or smell smoke during use.
• Do not use the device if the fan opening on the device is cracked, is becoming detached
or is missing entirely.
• Do not use the device if the skin colour sensor on the device or the light area is cracked
or broken.
• Do not direct the light pulse at any other surfaces other than the skin. Otherwise, this may
result in serious damage to the light emission window or the skin colour sensor. Damage
may also be caused to the flashed surface. Only activate the light pulse once the device
is in contact with the skin.
• After use, store the device in its original box.
• Do not expose the device to several hours of direct sunlight or UV light in order to pre-
vent damage.
31