Application Methods - Beurer PureSkin Pro Instrucciones De Uso

2. Press the ON/OFF/power selection button. On the intensity
display, a small light (level 1) begins to illuminate continuously
in green.
3. If you wish to carry out an application at a higher intensity level,
increase the intensity by repeatedly pressing the ON/OFF/power
selection button until you have reached the desired intensity.
4. Position the light area on the skin and press the trigger button
in order to release a light pulse. Ensure that the light area and
skin contact sensor come into full contact with the skin. A light
pulse can only be released once the skin contact sensor is
in full contact with the skin. You will see a bright flash, hear a
cracking noise and may feel a slight burning sensation and/or
warmth. The device fan switches on after the first flash. Within
1-3 seconds (depending on the intensity level), the device is
ready for the next pulse and the indicator lamp on the device is
continuously illuminated green.

6.1 Application methods

WARNING
Do not treat the same area twice within one treatment. The risk of side effects is increased
if an area is treated more than once.
Note
The pulses from the device should be applied in rows – beginning at one end of each row,
continuing to the other end. This technique allows better monitoring of the areas of skin that
have already been treated and helps you to avoid treating the same area more than once
or treating overlapping areas of skin. The light area of the device is designed in such a way
that it leaves a temporary impression on the treated area of skin. These visible impressions
can be used for precise placement of the next pulse.
Application method 1 "Auto Flash" mode:
Hold down the trigger button. The device emits a series of consecutive light pulses so long
as the skin contact sensor is in full contact with the skin. After the third light pulse, which
is triggered by holding down the trigger button, the device automatically switches to "Auto
Flash" mode. The device automatically emits light pulses at regular intervals. This mode
does not require the trigger button to be pressed manually. The "Auto Flash" mode is suit-
able for treating large areas in particular, for example the legs.
Application method 2 "releasing individual flashes":
Release the trigger button after each light pulse. For the next light pulse, position the device
on the area directly next to the area that has just been treated. Ensure that the light area
35