Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATION INSTRUCTIONS
1.
Lubricate the tool before operating. See "LUBRICATION &
MAINTENACE" section for oiling instructions.
2.
Lubricate the gears using a grease gun (not provided) to insert
the gun nozzle into the lubricating valve and several drops of
grease are recommended for lubrication. This will protect the
gears in good rotating condition and increases the tool life.
NOTE: The machine gears should be lubricated once every
working day.
3.
Mount a sanding paper (not provided) onto the Velcro face of
the sanding pad. Remove the air cap from the tool air inlet and
connect the air supply hose to the tool. Set the air pressure at
90 PSI. Push forward the throttle lever lock and press down on
the throttle lever. How far the throttle lever is pressed
determines the tool rotation speed.
REPLACEMENT OF SANDING PAD
1.
Disconnect the tool from air supply.
2.
Rotate by hand the orbit wheel and find the installation hole of
the orbit wheel from the hole of the front sleeve.
3.
Then insert the locking pin into the installation hole.
4.
Hold the locking pin firmly while releasing the sanding pad at
counter-clockwise.
5.
Re-mount a new sanding pad at clockwise by still holding the
locking pin firmly. Make sure the sanding pad is mounted onto
the tool tightly and securely.
Warning: Only use sanding pads that have an RPM rating equal to or
greater than the tool itself.
SW-Stahl und Werkzeugvertriebs GmbH
5
d i e
6
e
s
s
a r t S
h
c
s
m
e
R
Tel. +49 (0) 2191 / 46438-0
r e
F
ax +49 (0) 2191 / 46438-40
s
u
k r e
v
e
7
9
8
2
4 -
D
e
L
d . l h
a t s
w
s
@
o f n i
: l i
Publicidad
Tabla de contenido
