Stanley SB01AL Manual De Instruccion

x
20 LED FLEXIBLE WORK LIGHT
INSTRUCTION MANUAL
1
2
3
4 5 7
6
10
11
SAVE THIS INSTRUCTION MANUAL FOR FUTURE REFERENCE.
Copyright © 2017
Baccus Global LLC, Boca Raton, FL 33432
(877) 571-2391
SAFETY GUIDELINES / DEFINITIONS
DANGER: Indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury.
WARNING: Indicates a potentially hazardous situation which, if not avoided, could result in death or serious injury.
CAUTION: Indicates a potentially hazardous situation which, if not avoided, may result in minor or moderate injury.
CAUTION: Used without the safety alert symbol indicates potentially hazardous situation which, if not avoided, may result in
property damage.
RISK OF UNSAFE OPERATION. When using tools or equipment, basic safety precautions should always be followed to reduce the
risk of personal injury. Improper operation, maintenance or modification of tools or equipment could result in serious injury and
property damage. There are certain applications for which tools and equipment are designed. Manufacturer strongly recommends
that this product NOT be modified and/or used for any application other than for which it was designed. Read and understand all
warnings and operating instructions before using any tool or equipment.
IMPORTANT SAFETY INSTRUCTIONS
READ ALL INSTRUCTIONS
WARNING: Read all instructions before operating light. Failure to follow all instructions listed below may result in
electric shock, fire and/or serious injury.
SB01AL_ManualENSP_101117.indd 2
GENERAL SAFETY WARNINGS AND INSTRUCTIONS
SB01AL
WARNING: This product or its power cord contains lead, a chemical known to the State of California to cause cancer and birth
defect or other reproductive harm. Wash hands after handling.
WARNING – RISK OF FIRE, ELECTRIC SHOCK, BURST HAZARD, OR INJURY TO PERSONS – WHEN USING ELECTRICAL
APPLIANCES, BASIC PRECAUTIONS SHOULD ALWAYS BE FOLLOWED, INCLUDING THE FOLLOWING:
• Do not put light in water or other liquid. Do not place or store the light where it can fall or be pulled into water or become wet.
• Keep light lamp away from materials that may burn.
• Do not clean this appliance with a water spray or the like.
CAUTION – TO REDUCE THE RISK OF INJURY OR PROPERTY DAMAGE:
• Avoid dangerous environments:
– Do not operate the light near flammable liquids or in gaseous or explosive atmospheres. Internal sparks may ignite fumes
causing personal injury.
– Do not expose this unit to extremely high temperatures, flames or sparks.
• To reduce the risk of injury, close supervision is necessary when the light is used near children.
• Store idle appliances indoors. When not in use, appliances should be stored indoors in dry and high or locked-up places – out
of reach of children.
• Use of accessories and attachments. Use only attachments recommended or sold by the manufacturer.
• Check for damaged parts. A part that is damaged should be properly repaired or replaced by manufacturer before further use
unless otherwise indicated elsewhere in this instruction manual. Have defective switches replaced by manufacturer. Do not use this
appliance if the on/off button does not turn it on and off.
• Do not operate this unit with a missing or damaged lens.
• Do not touch the LED surface at any time.
• Never look directly into the light or shine the light into another person's eyes.
• Do not disassemble the main body of the unit. Other than the 3 "AA" size dry cell batteries, there are no user-replaceable parts.
ALKALINE BATTERY SAFETY INSTRUCTIONS
WARNING: Batteries can explode, or leak, and can cause injury or fire. To reduce this risk:
• Use only "AA" alkaline dry cell batteries in this unit.
• Carefully follow all instructions and warnings on the battery label and package.
• Always insert batteries correctly with regard to polarity (+ and –), marked on the battery and the equipment.
• Do not short battery terminals.
• Do not charge batteries.
• Do not mix old and new; or alkaline, standard (carbon-zinc) and rechargeable (nickel cadmium or nickel metal hydride) batteries.
Replace all of them at the same time with new batteries of the same brand and type.
• Remove dead batteries immediately and dispose of per local codes.
8
• Do not dispose of batteries in fire.
• Keep batteries out of reach of children.
• Remove batteries if the device will not be used for several months.
"Transporting batteries can possibly cause fires if the battery terminals inadvertently come in contact with conductive materials such
as keys, coins, hand tools and the like. The US Department of Transportation Hazardous Material Regulations (HMR) actually prohibit
9
transporting batteries in commerce or on airplanes (i.e. packed in suitcases and carryon luggage) UNLESS they are properly protected
from short circuits. So when transporting individual batteries, make sure that the battery terminals are protected and well insulated
from materials that could contact them and cause a short circuit."
SAVE THESE INSTRUCTIONS
INTRODUCTION
Congratulations on purchasing your new Flexible Work Light. Read this Instruction Manual and follow the instructions
12
carefully before using your new Flexible Work Light.
FEATURES
1. Light mode pushbutton (high/medium/off/flash)
2. 20 ultra bright LEDs
3. Flexible rubber groove stand
4. Back cover
5. Back cover screw
6. Magnetic discs (exposed to show details)
7. Battery compartment containing three (3) "AA" alkaline dry cell batteries (may be sold separately)
8. Back cover screw hole
9. Battery strap
10. Light holder (locks light on stand)
11. Magnetic base
12. Attachment bar (for securing the light to the light holder)
POWER SUPPLY
The unit is powered by three "AA" alkaline dry cell batteries (may be sold separately). Unscrew the back cover screw (counter-
clockwise) and remove the back cover. Gently pull the battery strap to remove the old batteries. Pull the strap gently so as not to
break it. Insert batteries as described in compartment, making sure the battery strap is first replaced beneath the new batteries,
observing the cautions that follow. Replace and secure the back cover by screwing the back cover screw clockwise. Do not be over-
tighten.
CAUTION: Follow all warnings regarding batteries in the Important Safety Instructions section of this manual.
OPERATING THE LIGHT
Position the unit, adjusting the flexible stand's legs or detaching the light and positioning using the magnetic discs as desired. Press
the light mode pushbutton on the top of the unit.
• Press once for high intensity.
• Press again for medium intensity.
• Press a third time for to turn the light off.
• Press and hold the light mode pushbutton for about five seconds for flashing LEDs.
Detaching the light from the flexible stand
TO DETACH THE LIGHT:
• Slide the attachment bar out of the light holder groove.
Once the light is detached, the magnetic discs allow you to position it on any metallic surface.
TO ATTACH THE LIGHT BACK ON THE STAND:
• Slide the attachment bar back into the light holder groove.
CAUTION – TO REDUCE THE RISK OF PRODUCT DAMAGE:
• When light is attached using the either the flexible stand or magnetic discs, do not shake the light or object that it is attached to.
Do not attach the light to any electrical wires or anything that it is not secure.
• Only use the flexible stand and magnetic discs for attaching the work light. The flexible stand and magnetic discs are not intended
to support additional weight. Do not attach anything additional to the light or risk of breakage may occur.
CARE AND MAINTENANCE
Never submerge the unit in liquids of any kind. If the unit gets dirty, gently clean the outer surfaces of the closed body casing with a
soft cloth moistened with a mild solution of water and detergent.
Except for the batteries, there are no user-serviceable parts inside. Contact the manufacturer if any components have become worn
or broken.
Safe Battery Disposal
Refer to the Safety Warnings in the front of this Instruction Manual when selecting and replacing batteries. Always dispose of used
batteries properly.
WARNING: TO REDUCE THE RISK OF INJURY/EXPLOSION:
• Do not dispose of batteries in fire as this may result in an explosion.
• Do not expose the unit containing batteries to fire or intense heat as it may explode.
TROUBLESHOOTING
Light will not operate
1. The back cover screw may be loose. Screw the back cover screw clockwise to secure. Do not over-tighten.
2. The batteries may be completely discharged. Replace the batteries following the directions given in this manual.
3. If the light does not operate after replacing the batteries and tightening the back cover, contact manufacturer at
(877) 571-2391.
ACCESSORIES
Recommended accessories for use with your tool may be available from the manufacturer. If you need assistance regarding
accessories, please contact the manufacturer at (877) 571-2391.
WARNING: The use of any accessory not recommended for use with this appliance could be hazardous.
SERVICE INFORMATION
Whether you need technical advice, repair, or genuine factory replacement parts, contact the manufacturer at (877) 571-2391.
ONE-YEAR LIMITED WARRANTY
The manufacturer warrants this product against defects in materials and workmanship for a period of ONE (1) YEAR from the date
of retail purchase by the original end-user purchaser ("Warranty Period").
If there is a defect and a valid claim is received within the Warranty Period, the defective product can be replaced or repaired in the
following ways: (1) Return the product to the manufacturer for repair or replacement at manufacturer's option. Proof of purchase
may be required by manufacturer. (2) Return the product to the retailer where product was purchased for an exchange (provided
that the store is a participating retailer). Returns to retailer should be made within the time period of the retailer's return policy
for exchanges only (usually 30 to 90 days after the sale). Proof of purchase may be required. Please check with the retailer for their
specific return policy regarding returns that are beyond the time set for exchanges.
This warranty does not apply to accessories, bulbs fuses and batteries, defects resulting from normal wear and tear, accidents,
damages sustained during shipping, alterations, unauthorized use or repair, neglect, misuse, abuse, and failure to follow instructions
for care and maintenance for the product.
This warranty gives you, the original retail purchaser, specific legal rights and you may have other rights which vary from state to
state or province to province. This product is not intended for commercial use.
Please complete the Product Registration Card and return within 30 days from purchase of the product to: Baccus Global LLC, One
City Centre, 1 North Federal Highway, Suite 200, Boca Raton, FL 33432. Baccus Global LLC, toll-free number: 1-877-571-2391.
SPECIFICATIONS
Work light: 20 bright white LEDs
Power source: 3 "AA" alkaline batteries (may be sold separately)
Imported by Baccus Global LLC,
One City Centre, 1 North Federal Highway, Suite 200, Boca Raton, FL 33432
www.Baccusglobal.com • 1-877-571-2391
RD101117
10/11/2017 12:00:05 PM