Getting Started - vitapur GWF8BLK Manual De Instrucciones

Assembly

GETTING STARTED

All of the following should be done with clean hands.
1. Remove Long Life Replacement Filter from plastic wrap.
2. Soak the long-life filter in cold tap water for 30 minutes before using.
3. Wash all parts (Except Long Life Replacement Filter and pre-filter) in warm
soapy water before initial use. THE PARTS ARE NOT DISHWASHER SAFE!
4. Rinse and dry thoroughly.
5. Once filter has soaked for 30 minutes, flush the filter under the tap for 30
seconds and shake gently.
LOWER CHAMBER ASSEMBLY
6. Check that the silicone plug has been installed and
locked onto the float securely.
7. Attach the float into the threaded float base at the
bottom of the lower chamber.
Place the assembled lower chamber on the
water dispenser.
Important: The Vitapur® Water Filtration System
is designed to fit all Vitapur® water dispensers
and most other brand names.
Depending on your water dispenser, you may
have to remove the bottle support collar from
your dispenser in order for the filtration system
to fit.
6
7