Oster 1691A Manual De Instrucciones página 4

INSTRUCTIONS FOR USE
BEFORE USING FOR THE FIRST TIME
Read and follow all the instructions for this section on use and care and find a place to keep
this instruction manual ready for future reference.
For your convenience, record the complete model number (located at the bottom of the
motor) and the date you received the product, together with your purchase receipt and
attach to the warranty and service information. Retain in the event that the warranty service
is required.
NOTE: The use of attachments not recommended or sold by Sunbeam Products, Inc. may
cause fire, electrical shock, injury or damage to the product.
1. Remove the thumbscrew from the bottom of the motor assembly (turning counter-
clockwise). Then attach motor assembly to base hole until snapped. Make sure to align
the notch on the motor assembly with the rib on the base. Tighten thumbscrew on the
bottom of the base (turning clockwise).
2. Remove the grill retaining nut (turning counter-clockwise) while holding motor housing.
Take off the motor shaft sleeve protector, if included, and discard.
3. Set the rear grill in the proper position (carry handle up) on the motor assembly, with
vertical openings at top and bottom fitting over notches. Then screw on the grill retaining
nut (turning clockwise) until tight.
4. Install the blade onto the shaft of the motor assembly and screw on the blade retaining
nut (turning counter-clockwise while holding the blade) until tight. Make sure that the fan
blade rests on the pin on the motor shaft.
5. Loosen the four clips on the front grill. Place the front grill on the rear grill with the Oster
logo upright. Snap all the clips into place.
001691A-814_13ESM1.indd 4
All manuals and user guides at all-guides.com
ASSEMBLY INSTRUCTIONS
3
®
5/21/13 9:30 AM