AXXAIR DC65-M1 Instrucciones De Manejo página 23

English

For the upper jaw, screw the nose of the raise and lower screw into the bore (so that
it rests against the upper jaw), then tighten screw IDIN912-M3x30 (tightening torque
= 1.23 Nm, 2.5 mm Allen key supplied).
Attention, if the jaw touches the inner face of the bore, the jaw tightening
system will be locked.
Finally, replace the front part of the DC65, taking care to align the pin with its groove.
Important note: these parts are precisely adjusted, so if they stick, do not force
them; remove the front part and try again.
- 23 -
Z.I. Les Bosses
F-26800 ETOILE-SUR-RHONE
www.axxair.com