Publicidad
Idiomas disponibles
Idiomas disponibles
Programming a calorie limit.-
Once you are in the main screen, you
press the ENTER key three times the
calorie window will start flashing. By
pressing the UP/DOWN key you can
program the calories for the exercise
(between
1-999
calories and press ENTER to confirm.
The calories will begin to count down
until they reach zero and the monitor
will beep several times to advise you
that
you
have
programmed value.
Programming the HEART RATE.-
Once you are in the main screen, you
press the ENTER key four times the
PULSE window will start flashing. By
using the UP/DOWN key you can
program the heart rate for the exercise
(between 20-220 bpm). Select the
heart rate and press ENTER to begin
the exercise. If the heart rate is equal
to or higher than the target value, the
monitor will beep several times to
warn the user to pedal more slowly or
reduce the exertion level.
TELEMETRIC PULSE RATE.-
The monitor is equipped to receive
signals
from
measurement system.
The system comprises of a receiver
and a transmitter (chest band) Fig.3.
See telemetric pulse rate instruction
book).
Cal).
Select the
reached
a
telemetric
TROUBLESHOOTING GUIDE.-
Problem: The display comes on but
only the Time function works.
Solution:
a.- Make sure that the connection
cable is connected.
Problem: The display does not come
on or the displayed segments are very
weak.
the
Solution:
a.- Check that the batteries are fitted
correctly.
b.- Check the battery charge.
c.- If they are run down change them
immediately.
Problem: Display segments of a
function read-out are not visible or
error
function appear.
Solution:
a.- Remove the batteries for 15
seconds and then refit them correctly.
b.- Check the battery charge If they
are run down change the batteries
c.- If the above steps do not help then
pulse
replace the electronic monitor.
Avoid leaving the electronic monitor in
direct sunlight as this might damage
the liquid crystal display. Similarly, do
not expose it to water or knocks.
Do not hesitate to get touch with the
Technical Assistance Service if you
have any queries by phoning customer
services (see last page in manual)
THE MANUFACTURER KEEPS THE
RIGHT TO MODIFY THE PRODUCT
SPECIFICATIONS
PREVIOUS ADVICE.
6
messages
for
a
particular
WITH
NO
Publicidad
