teutonia PICK UP: Manual De Instrucciones página 6

PICK UP
INT
Assembling the Ball
with a swivel device, the ball can be mounted on either
side. Put the two halves of the ball together over the
retention sleeves and fasten them with the enclosed
screws. Make sure that the ball is sitting rmly on the
axle and does not slip in order to ensure optimum
travel comfort. To remove the ball, proceed in reverse
order. If the PickUp is not used you do not need to
remove the ball.
Attaching the Footrest
6
The ball 2. to attach the
PickUp to the pram is made
up of two halves. Separate
the two halves of the ball
and remove the retention
sleeves. Place the retention
sleeves, which protect the
pram axles, centrally around
the pram axle and protec tive
tube 3. In the case of prams
After you have attached the
ball to the pram, pull back
the red operating lever 4.
and at the same time place
the footrest 5. on the ball.
When you release the ope-
rating lever, the footrest is
automatically xed.
Fitting the retaining belt (PickUp)
With the accompanying re taining belt, you have the
option of folding up the running board when it is not being
used. Push the insert buckle into the opening on the
PickUp 1, place the loose belt ends around the handle tu-
bes and close it
Caring for the PickUp
The axle ends have to be cleaned and lightly oiled
approx. every 4 weeks.