Harbor Breeze ARMITAGE CC52WW5C Manual Del Usuario página 9

WIRING
1c. FAN AND LIGHT CONTROLLED BY TWO
WALL SWITCHES: If you intend to control the
fan and light with separate wall switches,
connect BLACK wire from fan to BLACK wire
from the independent wall switch for the fan.
Connect BLUE wire from fan to the BLACK wire
from the other independent wall switch for the
light. Connect WHITE wire from fan to WHITE
wire from ceiling. Connect all GROUND (GREEN)
wires together from fan (on motor assembly and
mounting bracket) to BARE/GREEN wire from
ceiling. (Fig. 1C)
Note: BLACK wire is hot power for fan. BLUE wire
is hot power for light kit. WHITE wire is common
for fan and light kit. BARE/GREEN wire is ground.
2.
Wrap electrical tape around each individual wire
connector (CC) down to the wire.
WARNING: Make sure no bare wire or wire
strands are visible after making connections. Place
green and white connections on opposite side of box
from the black and blue (if applicable) connections.
Turn spliced/taped wires upward and gently push
wires and wire connectors (CC) into outlet box.
Hardware Used
CC
E3 Wire Connector
3. IMPORTANT: Using a full range dimmer switch to
control fan speed will cause a loud humming noise
from fan. To reduce the risk of fire or electrical
shock, do NOT use a full range dimmer switch to
control fan speed.
All manuals and user guides at all-guides.com
x 4
9
FAN AND LIGHT CONTROLLED BY TWO WALL SWITCHES
FAN AND LIGHT CONTROLLED BY TWO WALL SWITCHES
1c
BLACK (WALL SWITCH FOR LIGHT)
BLACK (WALL SWITCH)
120 V Power
WHITE WHITE
from ceiling
GROUND/GREEN (BARE)
BLACK
BLACK BLACK BLACK
BLUE BLUE
BLACK (WALL SWITCH)
3 2
CC
CC
CC
3 3
3
Dimmer
Switch
For illustrative purposes only--not
intended to cover all types of controls
Lowes.com/harborbreeze
D/G D/GREEN GREE N
WHITE WHITE
WHITE WHITE WHITE WHITE
FROM FAN FROM FAN
CC
3
2
1
Speed
Switch