Assembly; Unpack Pressure Washer; Assemble Handle And Water Inlet - Briggs & Stratton 1800 PSI Manual Del Operario

Assembly

Your pressure washer requires some assembly but is quickly
ready for use. If you have any problems with the assembly of
your pressure washer, please call the pressure washer
helpline at (800) 743-4115.
Tools Needed
• 4mm allen wrench (included)
• Needle nose pliers

Unpack Pressure Washer

1. Remove everything from carton except pressure
washer.
2. If pressure washer is too heavy for you to lift, open
carton completely by cutting each corner from top to
bottom.
Carton Contents
Check all contents. If any parts are missing or damaged, call
the pressure washer helpline at (800) 743-4115.
• Pressure washer
• Pressure washer handle
• Spray gun
• Nozzle extension with adjustable nozzle
• Nozzle extension with turbo nozzle
• Parts bag (which includes the following):
• Handle attachment allen screws (4)
• Operator's manual
• Owner's registration card
• Safety goggles
• Nozzle cleaning tool
Become familiar with each component before assembling the
pressure washer. Identify contents with the illustration
shown in Features and Controls.
Assembling Pressure Washer
Your Briggs & Stratton pressure washer will need assembly
before operation:
• Fill out and send in registration card.
• Assemble handle
• Attach spray gun holders
• Attach quick connect coupler to water inlet
6
Assemble Handle
1. Place handle (A) on top of pressure washer with red
handle above power cord and hole in handle aligned
with the screw holes in the back of the pressure
washer.
B
2. Using 4 supplied allen screws (B) , attach handle to
pressure washer with provided 4mm allen wrench.
Tighten until screws are snug.
Assemble Water Inlet Coupling
1. Remove and discard shipping cap from the unit's water
inlet using a needle nose pliers.
2. Confirm water inlet screen (C) is installed.
NOTICE: If inlet screen is damaged or missing, DO NOT use
pressure washer. Call (800) 743-4115 for assistance.
A
C
BRIGGSandSTRATTON.com