Checklist Before Starting Pressure Washer - Briggs & Stratton 1800 PSI Manual Del Operario

3. Run water through garden hose for 30 seconds to flush
the hose of debris. Turn off water.
4. Attach garden hose to water inlet coupling. Tighten by
hand.
NOTICE
Using a One Way Valve (vacuum breaker or check valve) at
pump inlet can cause pump or inlet connector damage.
• There MUST be at least ten feet of unrestricted garden hose
between the pressure washer inlet and any device, such as a
vacuum breaker or check valve.
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
IMPORTANT: Do Not siphon standing water for the water
supply. Use ONLY cold water (less than 100°F).
5. Attach quick connect high pressure hose (A) to spray
gun (B) by pressing hose quick connect fitting over
male quick connect fitting attached to gun. Tug on
connection to be sure it is securely attached.
B
A
6. Attach nozzle extension to spray gun by aligning the
locking tabs (C) into the grooves in the gun (D). Push
extension inward and twist clockwise to lock in place.
Tug on connection to be sure it is securely attached.
C
7. Turn ON water, point gun in a safe direction, press
trigger lock (red button) (E) and squeeze trigger to
purge pump system and spray gun of air.

Checklist Before Starting Pressure Washer

Review the unit to ensure you have performed all of the
following:
1. Be sure to read Safety Rules and Operation sections
before using the pressure washer.
2. Verify high pressure hose-to-gun connection is secure.
3. Verify that there are no kinks, cuts, or damage to the
high pressure hose.
4. Verify garden hose-to-pressure washer connection is
secure and leak free.
5. Provide proper water supply (not to exceed 100°F).
D
E
7