Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Example:
Press the Single-button (The display shows "SINGLE") on both CD-players. Start playback of CD1. As soon
as the current track of CD1 is finished, the player automatically starts CD2. The first CD-player goes into
Pause-mode. You can enter a new CD or memorize a Cue-point at the respective player in the Pause-Mode.
6.14 End of operation
Before you switch off the device, please make sure that no CD remains in the player. All memorized Cue-
points, samples and effect-parameters are stored inside the CD-player and can be also be recalled after
switching the CD-player off.
7. PRECAUTIONS
This CD player cannot be compared to conventional Hifi CD players. This player is much more rugged in
order to withstand the strenous road use and consistent transports of mobile discotheques.
Should you have further problems, please refer to the chart below.
The adjustments of the Pitchfader change the FM frequencies. Should the display repeatedly show "ERR"
adjust the frequencies.
Have the connections correctly been carried out?
Is your amplifier and your mixer properly adjusted?
Have you kept to all instructions given in this manual?
SYMPTOMS
Device does not react when swit-
ching on.
Player does not start operation
No sound
Does not read the program
Pop noise
Faderstart does not work
8. CLEANING AND MAINTENANCE
Disconnect from mains before starting maintenance operation!
We recommend a frequent cleaning of the device. Please use a soft lint-free and moistened cloth. Never use
alcohol or solvents!
There are no servicable parts inside the device. Maintenance and service operations are only to be carried
out by authorized dealers.
Should you need any spare parts, please use genuine parts.
If the power supply cable of this device becomes damaged, it has to be replaced by a special power supply
cable available at your dealer.
Should you have further questions, please contact your dealer.
All manuals and user guides at all-guides.com
POSSIBLE CAUSES
Connection to mains disrupted.
CD is badly positioned or dirty
Check the mixer and amplifier
connections
The player is in normal playback
mode
Mixer or amplifier connections
inapropriate
Missing Audio Out-connection
DANGER TO LIFE!
36/69
SOLUTION
Check
AC
plug
and
connection.
Reposition CD with label atop or
clean with a dry and soft cloth.
Possibly exchange connections.
Press the Play/Pause-button and
re-program
Check cable and jack quality
Connect the Audio Out-sockets
with the Line-input sockets of your
mixer
10602296X10NXS_V_1_0.DOC
AC
Publicidad
Tabla de contenido
