Technical Data; Intended Use; Safety Informations - BGS technic 3290 Manual De Instrucciones

TECHNICAL DATA

Sanding paper: 150 mm (6")
Free speed: 10000 rpm
Working pressure: 6.2 bar (90 psi)
Air Inlet: 1/4" NPT
Air consumption: 170 l/min. (6.0 cfm)
Sound pressure level (LpA): 82 dB(A)
Sound power level (LwA): 93 dB(A)
Vibration level: 7 m/s²
Recommended hose diameter: 10 mm (3/8")
ATTENTION
Read the operating instructions and all safety instructions contained therein carefully before using the
product. Use the product correctly, with care and only according to the intended purpose. Non-
compliance of the safety instructions may lead to damage, personal injury and to termination of the
warranty. Keep these instructions in a safe and dry location for future reference. Enclose the
operating instructions when handing over the product to third parties.

INTENDED USE

This air needle scaler is used to remove rust and paint from steel sheet.

SAFETY INFORMATIONS

When using pneumatic tools, fundamental precautionary measures must always be ensured in order
to reduce the risk of personal injury and property damage.
• Keep children and unauthorised persons away from the work area.
• Do not let any children play with the tool or its packaging.
• Make sure that the work area is sufficiently illuminated.
• Keep the work area clean, organised, dry and free from other materials.
• Do allow untrained persons work with this tool set.
• Ensure that the trigger is located in the OFF position when being connected to the compressed
air system.
• Do not carry out any modifications on the tool.
• Use only accessories that are dimensioned for use with compressed air tools.
• Disconnect the tool from the compressed air supply before installing accessories, when carrying
out maintenance work or the device is not being used.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Air Grinder
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
BGS 3290
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed