Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATION
TV mode – operating with the
remote control of the sound bar
1
Switch Soundbar into standby mode using
»POWER
ON/OFF«.
– The LED
lights up red.
A
2
Switch Soundbar on from standby mode using
8
»
«.
– The LED
lights up white.
A
Note:
After power on the source device "TV" is se-
7
lected automatically.
3
Adjust the volume using
4
Use »
« to mute the sound.
S
5
Switch Soundbar into standby mode using
»
8
«.
6
Switch Soundbar off using
OFF«.
TV mode – operating with the
remote control of the television
If the sound is only to be played through the sound
bar and the volume is to be controlled using the
remote control of the television, this must be set in
the TV. In the sound menu of your television, turn
off the TV speakers, turn on the audio output, and
select the status "Controllable". (This depends on
the television; see the operating instructions of the
TV.)
Turning on the sound bar
automatically
The sound bar will turn on from standby mode
automatically when there is an audio signal on
INPUT" sockets. It turns off after about
the
"RCA
15 minutes when the audio signal is no longer
present.
1
Switch Soundbar into standby mode using
»POWER
ON/OFF«.
– The LED
lights up red.
A
2
Switch on the television.
18
ENGLISH
All manuals and user guides at all-guides.com
------------------------------------------------------------------------------------------------------------------------------
–«.
»+
V« or
»V
»POWER ON/
3
To ensure that the sound bar powers on, adjust
the audio signal with the volume buttons on the
TV so that the power-on level is reached.
– The sound bar switches on.
– The LED
lights up white.
A
4
If the sound bar does not switch on, increase
the volume using the volume buttons on the TV.
Notes:
The volume can be set with the remote control
7
of the television.
If the output signal of the TV (and thus the
7
volume) is set too low, the sound bar may
not switch on after the TV is powered off and
back on. If this is the case, increase the output
signal of the TV with the remote control of
the television and use the
buttons of the remote control of the sound
bar to adjust the volume to the desired vol-
ume.
Caution:
If the sound bar was switched to standby
7
with the remote control (using the »
ton), automatic power-on is disabled. The
sound bar then needs to be switched on
again with this button.
Turning off the sound bar
automatically
If there is no audio signal on the
and
»AUX
IN« sockets, then the sound bar auto-
matically switches to standby after 15 minutes. To
use the sound bar again, switch it back on.
Operating with an external
device
1
If an "external" device is connected to the
»AUX
IN« socket, select this program source
with the »AUX« button of the remote control.
2
Switch to TV mode using the »TV« button of the
remote control.
»+
V« or
»V
–«
8
« but-
»RCA
INPUT«
Publicidad
Tabla de contenido
