Auto-On/Off Socket Outlet For Power Tools; Infinipulseclean - Blastrac BDC-1133PM Manual Original

D
BLASTRAC BDC-1133PM / BDC-1133PH / BDC-1133PHC
GB
4. Connect the tubes with the hose handle, twist
F
the tubes in order to ensure that they are prop-
erly fitted.
NL
5. Attach suitable nozzle to the tube. Choose noz-
zle depending on what type of material that is to
be picked-up. If used for dust extraction in con-
I
nection with dust producing tool then connect
end of suction hose with appropriate adapter.
N
6. Check that hose diameter setting corraspondes
to actual hose diameter.
S
7. Connect the plug into a proper electrical outlet.
8. Put the electrical switch into position I in order to
DK
start the motor.
SF
E
P
GR
TR
SLO
HR
SK
CZ
The hose diameter and the setting for suction hose
diameter must be the same.
PL
H
RO
ø21
ø27
BG
ø32
ø36
RUS
ø38
ø 36 = standard equipment
EST
LV
LT
JA
ZH
KO
TH
MS
20
Turn I:
Activate the machine
Turn :
Stop the machine. Permanent power
on socket
Turn :
Activate Auto-On/Off operation
Turn I+ Off: Activate the machine
with deactivated automatic filter
cleaning function
Turn + Off: Activate Auto-
On/Off operation with deactivated
automatic filter cleaning function
Speed control operation on separate
turning knob
ø21
ø27
ø32
ø36
ø38
3.2

Auto-On/Off socket outlet for power tools

CAUTION
Appliance socket.
The appliance socket is designed for electrical
auxiliary equipment; see technical data for refer-
ence.
1. Prior to plugging in an appliance, always switch
off the machine and the appliance that is to be
connected.
2. Read the operating instructions to the appliance
to be connected and observe the safety notes
contained in these.
An appliance socket with earthing contact is inte-
grated in the machine. An external power tool can
be connected there. The socket features permanent
power on, when the electrical switch is in position
, i.e. the machine can be used as an extension
cord.
In position the machine can be switched on
and off by the power tool connected. Dirt is picked
up from the source of dust immediately. To comply
with regulations, only approved dust producing tools
should be connected.
The maximum power consumption of the connected
electrical appliance is stated in section "Specifica-
tions".
Before turning the switch to position
that the tool connected to the appliance socket is
switched off.
3.3

InfiniPulseClean

The machine is equipped with an automatic filter
cleaning system, InfiniPulseClean. A frequent clean-
ing cycle will automatically run during operation to
ensure that suction performance is always at its
best.
If suction performance decreases or in extensive
dust applications a manually filter cleaning operation
is recommended:
1. Switch off the machine.
2. Close the nozzles or suction hose opening with
the palm of your hand.
3. Turn the switch to position „I" and let the ma-
chine operate at full speed for approx. 10 sec-
onds with the suction hose opening closed.
If suction power is still reduced take out the filter and
clean mechanically or replace filter.
For certain applications, like wet pick up, it is recom-
mended to turn off the automatic filter cleaning sys-
tem. For details see chapter 3.1.
*) Optional accessories / Option depending on model
ensure
Original instruction