COMO AUDIO Blu Manual Del Propietário página 5

3. Auxiliary input: Connect the analog audio out from another device such as a CD
player or MP3 player. This input accepts a 3.5mm connector. An adapter cable is
included if converting a stereo RCA audio cable such as the cable included with the
Como Audio Turntable. With Como Blu on, if the unit is in Bluetooth mode, push the
source knob briefly to switch to Aux mode. The LEDs will change from blue to green.
Push the Source knob again briefly to return to Bluetooth mode.
4. Headphone output: Connect a set of stereo headphones. The primary speakers will
be muted. This output accepts a 3.5mm connector.
5. Bass control: Rotate right for more bass. Rotate left for less bass. The center detent
is the recommended setting. The range impacted by the bass control is roughly
150Hz – 60Hz.
6. Speaker output: Connect the wired Como Blu Speaker's audio cable to this right
channel output. Use only the Como Audio Blu Speaker with this output. See
"Mono/Stereo switch".
7. Mono/Stereo switch: Keep this switch in the Stereo position unless the optional
Como Blu Speaker is not connected, in which case it should be placed in the Mono
position. In the stereo configuration, Como Blu will reproduce the left channel only
and the Como Blu Speaker will reproduce the right channel only. Accordingly, it is
suggested to position the Como Blu Speaker on the right side. The more distance
between the two speakers, the better the channel separation and the wider the
soundstage.
8. Battery compartment: Accepts the optional 2200mA 14.8V custom Li-Ion battery
pack. Use only a genuine Como Audio battery pack, as unauthorized batteries could
pose a fire risk and are not covered under warranty. The LEDs above the display will
cycle whenever the battery pack is charging in standby mode. See the section
marked "Battery Pack".
9. Bass Port/Carry Handle: Rest your palm on the top of the cabinet and insert your
fingers inside the port to carry. Do not obstruct the bass port otherwise.
5
EN