COMO AUDIO Blu Manual Del Propietário página 6

Connecting Bluetooth devices to Como Blu:
With Como Blu on, be sure it is in Bluetooth pairing mode (the LEDs will flash blue). If
Como Blu is in Aux mode (green LEDs), push the Source knob in briefly to switch to
Bluetooth mode. Open Bluetooth on your source device such as your smartphone or
computer and search/scan for "Como Audio Blu", then pair and connect on your phone.
EN
If your source device prompts you to enter a passcode, enter "0000". The Blu's flashing
blue LEDs will change to steady blue once connected. Adjust Como Blu's volume or your
source device's volume as desired. Como Blu will remember up to five paired devices.
Note when the audio first plays, the volume might ramp-up.
Setting the Clock:
If you use an iPhone, pair and connect your iPhone to Bluetooth following the above
instructions and the clock will set itself automatically within a few seconds using the
time from your iPhone.
Otherwise, to set the clock manually, press and hold the Source knob. The hour will
flash. Rotate the Source knob and press in to set the hour. The minutes will flash. Rotate
the Source knob and press in to set the minutes. If you make a mistake, repeat the
process.
If power is lost, including turning Como Blu off completely with no battery inside (or a
dead battery inside), the clock must be set again when Blu is powered on unless using
an iPhone.
Setting the Time Format:
Como Blu defaults to a 12 hour time format. To change this setting to a 24 hour time
format, with Como Blu in standby, simply press the source knob in twice. Repeat to
switch back to the 12 hour format.
Outdoor use:
Como Blu is splash-resistant but not waterproof. It should never be placed under
running water or submerged. Take care to keep the real wood veneer from being
exposed to moisture.
6