COMO AUDIO Blu Manual Del Propietário página 7

Battery Pack (optional):
To install the optional Como Audio 2200mA Li-Ion battery pack and make Como Blu
portable, remove Como Blu's rear battery cover. Snap the battery's male connector into
the female connector in Como Blu's battery compartment. The connectors will only fit
together one way. Insert the battery pack so the batteries are horizontal and tuck the
wire above the battery pack. Como Blu's amber LEDs will cycle when the battery is
charging in standby mode.
Results will vary depending on use, but at approximately 60% volume with a fully
charged battery, expect roughly 8 hours of playback time. Lower volume levels will
extend battery playback time. A depleted battery pack can take up to 5+ hours to fully
charge. When Como Blu's battery is running low and needs to be connected to the
power supply, a brief "Low Power!" spoken warning will sound.
When Como Blu is completely powered off (no clock showing), the amber charging LEDs
will not illuminate but the battery pack will still charge.
During extended periods of non-use, be sure Como Blu is kept at room temperature
with a 40% battery charge. If Como Blu's power adapter is plugged in continuously, it is
advisable every four months or so to operate it from the battery until it is depleted and
then fully recharge it in order to keep the battery conditioned. When Off, the battery
will last about 2.5 days as it will still maintain the time even though the display is off.
Spoken confirmations: It is not possible to adjust the volume on the spoken
confirmations or turn them off.
Connecting Como Audio's Turntable Analog:
1. Connect the audio cable that came with Turntable Analog to the Turntable's rear
output and set its switch to "Line out" (NOT "Phono out").
2. Connect the other end of the same audio cable to the 3.5mm adapter cable.
3. Plug the adapter cable's 3.5mm connector into Como Blu's rear Aux input.
4. If Como Blu is in Bluetooth mode (the LEDs above the display will be flashing blue
or steady blue), briefly push the Source knob to change from Bluetooth to Aux.
The LEDs above the display will turn green. Play a record and adjust Como Blu's
volume as desired.
5. To return to Bluetooth mode, press the Source knob briefly.
Connecting the Como Audio Bluetooth Turntable:
1. Turn the Como Audio Bluetooth Turntable's Bluetooth switch on (switch is
located on right side of turntable).
7
EN